Dehumidifier dryer

A dehumidifying and drying generator properly dries plastic materials. By optimally controlling the temperature, time, and air flow, moisture is properly removed without damaging the materials, and then prevents poor drying such as silver.

Dehumidifier dryer CA series

Dehumidifier dryer CA series

Feature
  • Compressed air is supplied to dehumidify and dry the materials.
  • An optional dehumidifying air generator can be installed to improve the drying capacity.
  • It can be easily installed by directly attaching it to the molding machine or placing it on the floor.

Dehumidifier dryer LUXOR series

Dehumidifier dryer LUXOR series

Overview
It is a drying system that sends dehumidified air with a stable low dew point to the material.
Features 1) Drying with stable low dew point
● Closed loop method that does not use outside air (International patent)
※ LS250 or above size
Normally, all drying systems perform by 3 stages, regenerating → heating → cooling to create dehumidified air, but the closed loop method does not use the outside air for cooling in the adsorption process, so there is no re-adsorption of moisture and the power of the adsorbent is applied. You can pull it out to the maximum. In addition, the replacement of the desiccant during maintenance costs about half the cost of the honeycomb rotor type. (Reference ratio from our data)
Feature 2) Revolutionary energy-saving system ETA process (International patent)
● Heat exchange technology (hopper with ETA)
Normal dehumidified air drying is an energy inefficient system because the drying air is heated by the drying hopper and cooled by the hopper, but the Motan dryer exchanges heat between this heating and cooling, so energy is used. It is highly efficient and saves electricity costs.
Features 3) Central system that improves productivity by saving space and labor
● Excellent drying capacity： A system can be installed by combining multiple drying hoppers according to the capacity of one dryer, and it can be dried at different temperatures. In addition, by linking with METROLINK, different types of dried materials can be supplied to multiple molding machines at the same time.

  • The necessary materials can be supplied at the required time.
  • By distributing multiple materials to each drying hopper, drying and stocking, and supplying only the necessary materials to each molding machine, it is possible to eliminate waste of drying time until the materials can be changed and dried.
  • The temperature of each material can be controlled, and heating and yellowing can be prevented.

As an option, an appropriate temperature control “ATN system” is available for the central system, depending on the amount of usage for each material.